Air Cylinders Model Selection 200 100 50 40 30 20 10 5 4 3 2 1 300 0 500 1000 1500 MB�ｭ100 ・ CA2�ｭ100 MB�ｭ80 ・ CA2�ｭ80 MB�ｭ63 ・ CA2�ｭ63 MB�ｭ50 ・ CA2�ｭ50 MB�ｭ40 ・ CA2�ｭ40 MB�ｭ32 10.00 1.00 0.10 0.01 0 15 30 45 60 75 100 125 150 175 200 250 300 350 400 50 40 30 20 10 5 4 3 2 1 0.5 0.4 0.3 0 100 200 300 400 500 600 700 800 900 1000 CM2�ｭ40 CM2�ｭ32 CM2�ｭ25 CM2�ｭ20 200 100 50 40 30 20 10 54 3 2 1 0.5 0.4 0.3 0.2 0.1 300 0 500 1000 1500 CG1�ｭ100 CG1�ｭ80 CG1�ｭ63 CG1�ｭ50 CG1�ｭ32 CG1�ｭ20 CG1�ｭ25 CG1�ｭ40 CJ2�ｭ10 CJ2�ｭ6 CJ2�ｭ16 2 Best Pneumatics q The maximum stroke at which the cylinder can be operated under a lateral load. The region that does not exceed the bold solid line represents the allowable lateral load in relation to the cylinder of a given stroke length. In the graph, the range of the broken line shows that the long stroke limit has been exceeded. In this region, as a rule, operate the cylinder by providing a guide along the direction of movement. Graph (14) Series MB: o32, o40, o50, o63, o80, o100 Series CA2: o40, o50, o63, o80, o100 Lateral load applied to the rod end fR (N) Cylinder stroke (mm) Graph (11) Series CJ2: o6, o10, o16 Cylinder stroke (mm) Graph (12) Series CM2: o20, o25, o32, o40 Lateral load applied to the rod end fR (N) Cylinder stroke (mm) Graph (13) Series CG1: o20, o25, o32, o40, o50, o63, o80, o100 Cylinder stroke (mm) The aspects indicated below may need to be taken into consideration, depending on how the Step 3 Lateral load applied to the rod end fR (N) Lateral load applied to the rod end fR (N) fR Bushing (Bearing) Front matter 32