Clip Fitting assembly Element part number: S0700-82A-1 1 set includes 10 pieces. (for 5 valves) Caution The fittings are blocked by a clip. After removing the corresponding valve and take out the clip with a tool such as watchmakers’ flat blade screwdriver, then replace the fittings. For mounting, insert the fitting until it strikes against the inside wall and then insert the clip to the specified position. When using other than SMC brand tube, confirm that the following specifications are satisfied with respect to the tube outside diameter tolerance. 1) Nylon tube within ±0.1 mm 2) Soft nylon tube within ±0.1 mm 3) Polyurethane tube within +0.15 mm, within .0.2 mm Do not use tube which do not meet these outside diameter tolerances. It may not be possible to connect them, or they may cause other trouble, such as air leakage or the tube pulling out after connection. Warning How to Replace One-touch Fittings How to Replace Silencers Other Tube Brands A single body ported valve has a built-in silencer. A dirty and clogged silencer may reduce cylinder speed or cause a malfunction. Replace the silencer periodically. To replace the silencer, remove the PR plate after removing the clip, and then remove the old element with a tool such as a flat blade screwdriver. Applicable tube O.D. Fitting assembly part no. Applicable tube o2 KJH02-C1 Applicable tube o4 KJH04-C1 Applicable tube o1/8" KJH01-C1 Applicable tube o5/32" KJH03-C1 * Part number is for one fitting assembly. Please order it in units of 10 pieces. Clip Fitting assembly Insert the element so that the longer side of the element is mounted vertically. PR plate Clip Element Proper tightening torque [N・m] 0.2 to 0.25 Body Ported Series S0700 Specific Product Precautions 2 Be sure to read this before handling. Refer to the back cover for Safety Instructions. For 3/4/5 Port Solenoid Valve Precautions, refer to “Handling Precautions for SMC Products” and the Operation Manual on SMC website, http://www.smcworld.com The cylinder port fittings are a cassette for easy replacement. The fittings are blocked by a clip inserted from the top of the valve. Remove the clip with a tool such as a flat blade screwdriver to remove fittings. For replacement, insert the fitting assembly until it strikes against the inside wall and then re-insert the clip to the specified position. Applicable tube O.D. Fitting assembly part no. 8.5 mm pitch (One-touch fitting) Applicable tube o2 VVQ0000-50A-C2 Applicable tube o3.2 VVQ0000-50A-C3 Applicable tube o4 VVQ0000-50A-C4 Applicable tube o1/8" VVQ0000-50A-N1 Applicable tube o5/32" VVQ0000-50A-N3 7.5 mm pitch (Barb fitting) Barb fitting o2 SS070-50A-20 Barb fitting o3.2 SS070-50A-32 Barb fitting o4 SS070-50A-40 * Part number is for one fitting assembly. Please order it in units of 10 pieces. Base Mounted Clip Fitting assembly 27